Toro Titan MX6000 - Inspecting the Belts

Figure62
1.Bladesfronttorear3.Measurefromthetipofthe
bladetotheatsurface
here
2.Outsidecuttingedges
LevelingtheMowerDeck
1.Setanti-scalprollerstotopholesorremovecompletely
forthisprocedure;refertoAdjustingtheAnti-Scalp
Rollers(page23).
2.Settheheight-of-cutlevertothe76mm(3inch)
position;refertoAdjustingtheHeight-of-Cut(page
22).
3.Placetwo6.66cm(2-5/8inch)blocksundereach
sideofthefrontedgeofthedeck,butnotunderthe
anti-scalprollerbrackets(Figure63).
4.Placetwo7.30cm(2-7/8inch)thickblocksunderthe
rearedgeofthecuttingdeckskirt;oneoneachsideof
thecuttingdeck(Figure63).
Figure63
1.Woodblock,6.66cm
(2-5/8inch)thick
3.Frontedge
2.Woodblock,7.30cm
(2-7/8inch)thick
5.Loosentheadjustmentboltsonallfourcornerssothat
thedeckissittingsecurelyonallfourblocks(Figure
64).
Figure64
1.Deckliftarm
3.Hook
2.Chain
4.Adjustmentbolt
6.Ensurethereistensiononallfourchains(Figure64).
7.Tightenthefouradjustmentbolts(Figure64).
8.Checkthatblockstjustsnuglyunderthedeckskirt.
Makesureallboltsaretight
9.Verifythatthedeckislevelbycheckingtheside-to-side
levelandfront-to-rearbladeslope;repeatthedeck
levelingprocedureifnecessary.
InspectingtheBelts
ServiceInterval:Every50hours
Checkthebeltsforsquealingwhenthebeltisrotating,blades
slippingwhencuttinggrass,frayedbeltedges,burnmarksand
cracksaresignsofawornmowerbelt.Replacethemower
beltifanyoftheseconditionsisevident.
Note:Lifttheoorpantogainaccesstothebeltandidler
pulley.
44