Toro TITAN ZX6020 - Safely Stopping the Machine; Adjusting Mower Cutting Height

StoppingtheMachine
Tostopthemachine,movethetractioncontrolleversto
neutralandmovetolockedposition,disengagetheblade
controlswitch(PTO),andturntheignitionkeytooff.
Settheparkingbrakewhenyouleavethemachine;referto
SettingtheParkingBrake(page21).Remembertoremove
thekeyfromtheignitionswitch.
CAUTION
Childrenorbystandersmaybeinjuredifthey
moveorattempttooperatethetractorwhileitis
unattended.
Alwaysremovetheignitionkeyandsettheparking
brakewhenleavingthemachineunattended,even
ifjustforafewminutes.
AdjustingtheHeightofCut
Themachineisequippedwithafootpedaldeckliftsystem.
Theoperatorcanusethefootpedaltoliftthedeckbrieyto
avoidobstaclesorlockthedeckinthehighestheight-of-cut
ortransportposition.Theoperatorcanusetheheightof
cutleverwiththefootpedaltolockthedeckinaspecic
cuttingheight.
UsingtheFootPedalDeckLiftSystem
•Pressthepedaldowntoraisethedeck;continuetopress
thepedaluntilthedeckislockedinthetransportposition
(Figure27).
•Pushonthedeckliftpedalwithyourfootandraisethe
height-of-cutleverslightlytodisengagethetransportlock
(Figure27).
G010219
Figure27
TransportLockPosition
AdjustingtheHeight-of-Cut
Theheight-of-cutcanbeadjustedfrom38to114mm(1-1/2
to4-1/2inch)in6mm(1/4inch)incrementsbyrelocating
theheight-of-cutpinintodifferentholelocations.
1.Pushonthedeckliftpedalwithyourfootandraisethe
mowerdecktothetransportposition(alsothe114mm
(4-1/2inch)cuttingheightposition)(
Figure28).
2.Toadjust,removethepinfromtheheight-of-cut
bracket(
Figure28).
3.Selectaholeintheheight-of-cutsystemcorresponding
totheheight-of-cutdesiredandinsertthepin
(Figure28).
25