Operation
22
Headlights and Taillights
The headlights and taillights are turned on by turning
the ignition key to the LIGHTS position. They can be
turned on even if the engine is not running. Remove
the ignition key when leaving the machine unattended
so that the headlights cannot be turned on and
discharge the battery.
m–3312
1
Figure 20
1. Lights
Positioning the Tilt Steering
Wheel
The steering wheel has four tilt locations. Position the
steering wheel where you have the best control of the
machine and are most comfortable.
1. Lift the tilt lever to release the lock (Fig. 21).
2. Move the steering wheel to a comfortable
position; then release the lever to lock it in place.
1
2
m–3259
Figure 21
1. Tilt lever 2. Steering wheel
Using the Cruise Control
The cruise control is a switch (Fig. 22) on the right
fender that maintains a set traction control position
without foot pressure. The cruise control only
operates when moving forward.
m–3313
1
Figure 22
1. Cruise control
Engaging the Cruise Control
1. Begin driving the tractor; refer to Driving
Forward or Backward, page 19. While holding
your foot steady on the traction control pedal,
push the cruise control switch (Fig. 22) to the
“SET” position. This locks the traction control in
position and your foot can then be removed from
the traction control. A constant pedal position
will be maintained.
2. The cruise control has a “speed–up” feature: If
you initially set it to any speed other than full
speed, you can speed up with your foot on the
traction pedal for as long as you wish. When you
release the traction pedal, the pre–selected cruise
speed resumes automatically.
Disengaging the Cruise Control
1. While holding your foot steady on the traction
control, move the cruise control switch (Fig. 10)
to the “OFF” position.
2. This unlocks the traction control. You must now
use the traction control to move forward.
To Next Page
Loading...
Need help?
General
