Maintenance
38
Battery
Service Interval/Specification
Check the electrolyte level in the battery every 25
hours. Always keep the battery clean and fully
charged. Use a paper towel to clean the battery case.
If the battery terminals are corroded, clean them with
a solution of four parts water and one part baking
soda. Apply a light coating of grease to the battery
terminals to prevent corrosion.
Battery size: 12 v, 380 Cold Cranking Amps
Checking the Electrolyte Level
1. Park the machine on a level surface. Disengage
the power take off (PTO), set the parking brake,
lower the attachment lift, and turn the ignition
key to “STOP” to stop the engine. Remove the
ignition key.
2. Remove the front grill by pulling it outward
toward you.
3. Remove the battery shield.
4. Open the cell covers to see into the cells. The
electrolyte must be up to the lower part of the
tube (Fig. 52). Do not allow the electrolyte to get
below the plates.
5. If the electrolyte is low, add the required amount
of distilled water; refer to Adding Water to the
Battery.
6. If the fluid level is correct, press the cell covers
onto the battery and replace the battery shield.
IMPORTANT: Keep the battery shield in
place to protect the battery from heat.
7. Replace the grill.
1
Figure 52
1. Lower part of the battery
cell tube
Adding Water to the Battery
IMPORTANT: Use only distilled water.
The best time to add distilled water to the battery is
just before you operate the machine. This lets the
water mix thoroughly with the electrolyte solution.
1. Clean the top of the battery with a paper towel.
2. Lift off the filler caps (Fig. 52).
3. Slowly pour distilled water into each battery cell
until the level is up to the lower part of the tube
(Fig. 52).
IMPORTANT: Do not overfill the battery
because electrolyte (sulfuric acid) can cause
severe corrosion and damage to the chassis.
4. Press the cell covers onto the battery.
5. Replace the battery shield.
IMPORTANT: Keep the battery shield in
place to protect the battery from heat.
6. Replace the grill.
To Next Page
Loading...
Need help?
General
