Toro Workman HD Series - Page 116

Workman HD SeriesPage 6 − 46Drive Train
13.Assemble shift arms:
A. Install new oil seals into transaxle case. Apply
multi−purpose grease on lips of oil seals before
installing.
B. Install keeper plates and tighten flange head
screws to a torque from 11 to 13 ft−lb (15 to 17
N−m).
C. Apply Loctite #680 (or equivalent) to threads and
tapers of shift fork arms.
D. Install shift arms. Install shift arm assembly.
E. Install lock nuts. Tighten shift arm retaining lock
nuts to a torque from 230 to 240 in−lb (26 to 27
N−m).
1
2
3
1. Flange head screw (3)
2. Keeper plate (3)
3. Oil seal (3)
Figure 83
11 to 13 ft−lb
(15 to 17 N−m)
11
8
10
9
7
6
12
4
5
Apply Loctite #680
to threads and tapers
12
11
230 to 240 in−lb
(26 to 27 N−m)
4. Lock nut
5. 2
nd
−3
rd
shift arm
6. Shift arm plate
7. Spring
8. Lock nut
9. Washer
10. Cap screw
11. Lock nut
12. Shift arm (2)
Figure 84
14.Install oil cap with O−ring. Apply multi−purpose
grease to O−ring.
15.If removed, install air breather. Use sealing tape on
threads of air breather.
1
2
1. Oil cap 2. Air breather
Figure 85
Drive Train