Toro Workman HD Series - Page 117

Workman HD Series Page 6 − 47 Drive Train
16.Assemble reduction shaft and countershaft together
with R−1 fork shaft and Hi−Lo fork shaft.
Figure 86
17.Insert reduction shaft and countershaft assembly
into transaxle case. Insert heads of shift arms into
grooves of forks when installing them.
Figure 87
18.Assemble main shaft together with 2−3 fork shaft.
Figure 88
19.Insert main shaft and 2−3 fork shaft assembly into
transaxle case. Insert head of shift arm into groove of
fork while installing.
Figure 89