Toro Workman HD Series - Page 121

Workman HD Series Page 6 − 51 Drive Train
B. Insert steel balls and springs into the grooves.
1
2
3
1. Spindle
2. Spring (2)
3. Ball (2)
Figure 99
C. Apply silicone sealant to mating surface of fork
shaft case.
D. Install fork shaft case. Install and tighten flange
head screws to a torque from 18.5 to 22 ft−lb (24.5
to 29.5 N−m).
E. Check operation of shifters and detent.
1
3
2
2
2
1. Flange head screw (1)
2. Flange head screw (3)
3. Fork shaft case
Figure 100
18.5 to 22 ft−lb
(24.5 to 29.5 N−m)
28.Insert a washer into housing of transaxle case. Apply
moly disulfide grease to washer before installing.
1
1. Washer
Figure 101