Toro Workman HD Series - Page 128

Workman HD SeriesPage 6 − 58Drive Train
8. Remove PTO input shaft from PTO housing:
A. Shift PTO to ”ON” position.
B. Remove retaining rings from PTO housing.
C. Slide input shaft assembly toward PTO shaft.
D. Remove bearing (item 4).
E. Slide input shaft away from PTO shaft.
F. Remove bearing.
G. Remove thrust washer and gear by sliding input
shaft toward PTO shaft.
H. Release shift arm from shifter block.
I. Remove input shaft assembly.
Moly disulfide
grease
1. Retaining ring
2. Retaining ring
3. Input shaft assembly
4. Bearing
5. Bearing
6. Thrust washer
7. Gear
8. Shift arm
9. Shifter block
Figure 117
6
8
3
7
3. Input shaft assembly
6. Thrust washer
7. Gear
8. Shift arm
Figure 118
9. Disassemble PTO input shaft:
A. Remove shift collar.
B. Remove steel balls and spring.
1
2
2
3
1. Shift collar
2. Steel ball (2)
3. Spring
Figure 119