Toro Workman MDX Service Manual

Workman MD/MDX Page 7 -- 43 Chassis
Removal (Fig. 27)
1. Park machine on a level surface, stop engine, set
parking brake and remove key from the ignition.
2. Remove hood using Figure 27 as a guide.
Installation (Fig. 27)
NOTE: Do not tighten fasteners securing the hood until
all fasteners are in place.
1. Install hood using Figure 27 as a guide. During as-
sembly, use fastener torque specifications that are iden-
tified in Figure 28.
Chassis

Toro Workman MDX Specifications

General

Brand	Toro
Model	Workman MDX
Category	Utility Vehicle
Language	English