Toro Z Master 74925TE User Manual

Toro Z Master 74925TE

88 pages

To Next Page

To Next Page

Page #1 background image

Loading...

Page #1 background image

FormNo.3433-908RevA

ZMaster

®

Professional5000or

6000SeriesRidingMower

with48in,52in,60in,or72inTURBOFORCE

®

Mower

ModelNo.72904—SerialNo.400000000andUp

ModelNo.72906—SerialNo.400000000andUp

ModelNo.72918—SerialNo.400000000andUp

ModelNo.72926—SerialNo.400000000andUp

ModelNo.72928—SerialNo.400000000andUp

ModelNo.72930—SerialNo.400000000andUp

ModelNo.72943—SerialNo.400000000andUp

ModelNo.72945—SerialNo.400000000andUp

ModelNo.72951—SerialNo.400000000andUp

ModelNo.72955—SerialNo.400000000andUp

Registeratwww.Toro.com.

OriginalInstructions(EN)

*3433-908*A

Table of Contents

Other manuals for Toro Z Master 74925TE

Setup Instructions16 pages

Questions and Answers:

P
Patrick WilliamsAug 27, 2025
Why Toro Lawn Mower blades do not rotate?
- J
  jordanpaulAug 27, 2025
  If the blades on your Toro Lawn Mower aren't rotating, it could be due to a worn, loose, or broken mower deck belt; in this case, install a new deck belt. Another possibility is that the mower deck belt is off the pulley; reinstall it and check the idler pulley, idler arm, and spring for correct position and function. Also, check the pump drive belt for wear, looseness, or breakage, and adjust the belt tension or install a new belt. Finally, inspect the idler spring and replace it if it's broken or missing.
V
Victoria PaulAug 27, 2025
Why won't my Toro Z Master 74925TE engine start, starts hard, or fails to keep running?
- S
  Shane CalderonAug 27, 2025
  If your Toro Lawn Mower engine will not start, starts hard, or fails to keep running, fill the fuel tank, open the fuel shutoff valve and add oil to the crankcase. Ensure that the throttle control is midway between the “SLOW” and “FAST” positions. Also, replace the fuel filter, clean or replace the air cleaner element, check the seat switch indicator (replace the seat if needed), check the electrical connections for good contact (clean the connector terminals thoroughly with electrical contact cleaner, apply dielectric grease, and reconnect), clean, adjust, or replace the spark plug and check the spark plug wire connection. If problems persist, contact an Authorized Service Dealer.
W
William TurnerAug 28, 2025
What to do if my Toro Z Master 74925TE Lawn Mower engine loses power?
- R
  Robert KaneAug 28, 2025
  If your Toro Lawn Mower engine is losing power, consider the following: * Reduce the ground speed if the engine load is excessive. * Clean the air-cleaner element. * Add oil to the crankcase if the oil level is low. * Remove any obstructions from the cooling fins and air passages above the engine. * Clean or replace the fuel cap if the vent hole is plugged. * Replace the fuel filter if it is dirty.
H
hartmancurtisAug 28, 2025
Why don't the blades rotate on my Toro Z Master 74925TE Lawn Mower?
- K
  Keith BruceAug 28, 2025
  If the blades on your Toro Lawn Mower aren't rotating, it could be due to: * A worn, loose, or broken mower deck belt; install a new deck belt. * The mower deck belt being off the pulley; install the mower deck pulley and check the idler pulley, idler arm, and spring for correct position and function. * A worn, loose, or broken pump drive belt; check the belt tension or install a new belt. * A broken or missing idler spring; replace the spring.
T
Teresa MelendezAug 29, 2025
What to do if my Toro Z Master 74925TE Lawn Mower doesn't drive?
- C
  Candice AbbottAug 29, 2025
  If your Toro Lawn Mower doesn't drive, try these steps: 1. Tighten the by pass valves. 2. Change the belt. 3. Replace the spring. 4. Add hydraulic oil to reservoirs or let it cool down.
S
Stacy JohnsonAug 29, 2025
How to fix uneven cutting height with my Toro Z Master 74925TE?
- K
  Kyle HaynesAug 29, 2025
  An uneven cutting height with your Toro Lawn Mower may be due to dull blades, bent cutting blades, an unlevel mower deck, a dirty mower underside, or incorrect tire pressure. Try to sharpen the blades, install new cutting blades, level the mower deck from side-to-side and front-to-rear, clean the underside of the mower, and adjust the tire pressure. For a bent blade spindle, contact an Authorized Service Dealer.
J
John AdamsAug 29, 2025
Why is my Toro Lawn Mower engine losing power?
- S
  Sarah CollinsAug 30, 2025
  Your Toro Lawn Mower engine might be losing power due to several reasons: * The engine load could be excessive; reduce the ground speed. * The air cleaner might be dirty; clean the air cleaner element. * The oil level in the crankcase may be low; add oil to the crankcase. * The cooling fins and air passages above the engine could be plugged; remove the obstruction. * The vent hole in the fuel cap may be plugged; clean or replace the fuel cap. * There may be dirt in the fuel filter; replace the fuel filter.
V
Victoria MullinsAug 25, 2025
Why does my Toro Z Master 74925TE Lawn Mower engine not start, start hard, or fail to keep running?
- S
  Sean CampbellAug 25, 2025
  Several factors can cause your Toro Lawn Mower engine to fail to start, start with difficulty, or stall. Here are a few things to check: * Ensure the fuel tank is full. * Verify the fuel-shutoff valve is open. * Check that the oil level in the crankcase is adequate. * Position the throttle control midway between the slow and fast positions. * Replace a dirty fuel filter. * Clean or replace the air-cleaner element. * Check the spark-plug wire connection and adjust or replace the spark plug, if needed. Also, inspect the seat-switch indicator and replace the seat if necessary and check the electrical connections for good contact, cleaning them with electrical-contact cleaner and applying dielectric grease.
J
John PhillipsAug 30, 2025
How to fix uneven cutting height on Toro Lawn Mower?
- T
  Timothy SchwartzAug 30, 2025
  To fix an uneven cutting height on your Toro Lawn Mower, start by sharpening any dull blades or installing new ones if bent. Ensure the mower deck is level from side-to-side and front-to-rear. Clean the underside of the mower deck, adjust the tire pressure to the correct level. For a bent blade spindle, contact an Authorized Service Dealer.
J
Jordan MorrisAug 30, 2025
Why is my Toro Z Master 74925TE resulting in uneven cutting height?
- G
  gsharpAug 30, 2025
  If your Toro Lawn Mower is mowing with an uneven cutting height, several factors could be responsible. Ensure the blades are sharp; if not, sharpen them. Bent cutting blades can also cause this, so install new ones. Check if the mower deck is level from side-to-side and front-to-rear, and adjust as needed. A dirty underside of the mower can interfere with cutting, so clean it. Also, verify that the tire pressure is correct. For a bent blade spindle, contact an Authorized Service Dealer.

Toro Z Master 74925TE Specifications

General

Brand	Toro
Model	Z Master 74925TE
Category	Lawn Mower
Language	English

Related product manuals

Preview: Toro 74923 Z Master 6000

Toro 74923 Z Master 6000

Preview: Z Master Professional 6000 74922

Z Master Professional 6000 74922

Toro Z Master 74915

Toro Z Master 74916

Toro Z Master 74958

Preview: Toro Z Master 74941CP

Toro Z Master 74941CP

Preview: Toro 74915 Z Master G3

Toro 74915 Z Master G3

Preview: Toro 74901 Z Master 5000

Toro 74901 Z Master 5000

Preview: 74991 Z Master Professional 5000 Series

74991 Z Master Professional 5000 Series

Preview: Toro Z Master 74141

Toro Z Master 74141

Toro 74242 Z500 Z Master

Toro 74408 Z334 Z Master