Toro Z500 Series Z Master - Installing the Roll over Protection System

Figure 2
2. Raise the bac k of the mac hine up and suppor t
it with jac k-stands ( Figure 3 ).
Figure 3
3. R emo v e the wheel n uts from both sides of the
v ehicle and remo v e the right angle retaining
plate ( Figure 4 ). Discard the screws and
retaining plate .
Figure 4
4. Mount the wheels with the v alv e stem to the
outside and secure them with the wheel n uts
previously remo v ed ( Figure 5 ).
Figure 5
5. T or que the wheel n uts to 95 ft-lb (128 N·m).
6. R emo v e the jac k-stands .
Step
4
Installing the Roll Over
Protection System
Parts needed for this step:
1
Roll bar, right section
1
Roll bar, left section
1
Roll bar, center section
8
Bolt, (3/8 x 1 inch)
8
Curved washer
8
Flange nut, (3/8 inch)
2
Bolt, (1/2 x 3–1/4 inch)
2
Flange nut, (1/2 inch)
Procedure
1. Loosely install the right and left roll bar section
to the frame , with 8 bolts (3/8 x 1 inc h), 8
cur v ed w ashers , and 8 flang e n uts (3/8 inc h).
Note: T he cur v e w asher cone m ust be
installed to w ard the bolt head.
3