Toro Z500 Series Z Master - Page 9

7. Align the holes in the air cleaner brac k et with
holes in the v alv e co v ers ( Figure 24 ).
8. Install the long carburetor bolts into the
air cleaner base and into the carburetor
( Figure 23 ).
Figure 23
9. Install the hose clamp onto the hose and install
the hose to the air cleaner ( Figure 24 ).
10. Install the bolts into the bac k of the air cleaner
brac k et and into the motor ( Figure 24 ).
11. Tighten the hose clamp .
Figure 24
12. Install the front engine co v er with 4 screws .
Figure 25
Step
10
Checking the Spindles for
Grease
Parts needed for this step:
1 tube
Number 2 general purpose lithium base
or molybdenum base grease. (Purchase
separately.)
Procedure
1. R emo v e the belt co v ers on domestic mac hines
( Figure 26 ).
Figure 26
2. R emo v e the belt co v ers and bolts on
inter national mac hines ( Figure 27 ).
9