64
Learning the Basics
Starting a program
5.375 x 8.375 ver 2.3
To turn off the cursor control overlay, hold down the Fn key
and press
F10 again. The cursor control mode light on the
keyboard indicator panel goes out.
Starting a program
The easiest way to start a program is to double-click the name
of the file that contains the information you want to work on.
To find the file, use My Computer or Windows Explorer.
If you prefer to open the program first, you have four options:
❖ Double-click the icon for the program on your desktop
❖ Use the Start menu
❖ Use Windows Explorer to locate the program file
❖ Use the Run dialog box
The Windows
®
XP operating system tutorial chapter gives
step-by-step instructions for starting a program from the Start
menu. See “Lesson 6: Starting programs” on page 108.
Saving your work
Before you turn off the computer, save your work to the hard
disk drive or a diskette.
NOTE: Always save your data even when you are using the
Stand by command. If your battery fully discharges, your
information will be lost. Your computer can be configured to warn
you when the battery is running low, see “Power management” on
page 87.
Many programs offer a feature that saves documents at
regular intervals, such as every 15 minutes. Check your
programs’ documentation to see whether they have an
automatic save feature.
To Next Page
Loading...
Need help?
General
