Toshiba 24PB2 Series - Watching TV and Selecting Inputs; Selecting Video Input Source

– 11 –
Watching TV programmes
Selecting the menu language
Choose from 9 different languages (English,
Chinese (CS), Malay, Thai, Vietnamese, Russian,
Arabic, Persian or French) for the on-screen
display.
• Use the menu: SETUP
• Use the item: Language
Changing the position
1 Enter the desired position number using the
Number buttons on the remote control.
For positions below 10, use 0 and the
required number e.g., for position 1.
2 You can also change the position by using
PU or Pu.
The position will be displayed on the screen
with the Mono/Stereo/Dual audio status.
Note:
Changing positions between different format
channels takes several seconds.
Switching between two positions
You can switch two positions without entering
actual position number each time.
1 Select the  rst position you want to view.
2 Select the second position with the Number
buttons (0-9).
3 Press . The previous channel will be
displayed.
Each time you press
, the TV will switch
back and forth between the two positions.
Changing the position
1 Press to display the following on-screen
information.
4 ABCD
Stereo
The information will disappear in 6 seconds.
To erase the display instantly, press again.
Sorting positions
Ex.: To swap channel ABCD (Prog.1) for channel
MNOP (Prog.4):
1 From the SETUP menu, press  or  to
select Manual Tuning menu, and then press
Q.
2 Press  or  to select the channel ABCD,
then press .
1 ABCD
EFGH
IJKL
MNOP
Manual Tuning
Pos. Label
2
3
4
5
3 Press  to select the new position “4”, then
press .
4 Press  to select the channel MNOP, then
press .
5 Press  to select the new position “1”, then
press .
6 Con rm new Manual Tuning menu.
Selecting the video input source to view
1 Press on the remote control until
the video input mode list appears on the
screen, then press ,  or to select
appropriate input source (or press o on the
TV left side panel to select required input
source directly).
2 Press OK.
TV (analogue aerial input),
VIDEO (o COMPONENT / VIDEO INPUT,
standard or component video input),
HDMI (HDMI input),
PC (o RGB/PC, PC input)
Setting the Manual Setting menu
When the standard video input mode, this
function is available.
• Use menus: SETUP and Manual Settings
• Use items: Colour System and Label
Channel List
1 Press the button. The Channel List will
appear.
2 Press  or  to select a channel, and press
Q to watch.
Selecting the PC/HDMI Audio mode
You can select PC audio or HDMI audio when
using this function.
• Use menus: SETUP and AV Connection
• Use the item: PC/HDMI Audio
• Use modes: PC and HDMI
2432PB2SeriesEn.indd112432PB2SeriesEn.indd11 2011/09/289:40:332011/09/289:40:33