Toshiba 24PB2 Series - Using the Media Player

– 18 –
• Use menus: SETUP and PC Settings
• Use the item: Clock Phase
Adjusting the Sampling Clock
If the Sampling Clock does not match with the
dot clock frequency of the PC, blurred picture
detail will occur, or screen width will change, or
drift patterns in vertical lines may be apparent.
This function enables you to adjust it and
optimize the picture.
• Use menus: SETUP and PC Settings
• Use the item: Sampling Clock
Resetting the PC Settings
The Reset function adjusts the PC Settings to
the factory settings.
• Use menus: SETUP and PC Settings
• Use the item: Reset
Note:
When a PC is connected using HDMI none of
these function will be available.
Using the Media Player
The TV allows you to enjoy photos stored on a
USB device.
Notes:
• Do not insert/remove a USB device while in use.
• MENU is not available during playback.
Media Player Specifi cations
Device
USB device:
USB Mass Storage Class devices (MSC)
Notes:
•
Connectivity is not guaranteed for all devices.
• Connect the USB device to the TV directly.
• Do not use a USB hub.
Supported fi le system
FAT16 and FAT32
You must obtain any required permission
from copyright owners to download or use
copyrighted content. Toshiba cannot and
does not grant such permission.
Basic operation
Auto Start:
1 From the FUNCTION menu, highlight Media
Player and press Q.
Media Player
Photo
Auto Start
On
2 Press  or  to highlight Auto Start.
3 Press  or  to select On.
4 Insert a USB device into the USB terminal on
the left side of the TV.
5 A con rmation message will appear.
Highlight Yes, and then press Q.
6 Press  or  to select Photo, and then
press Q. The list window of  les will appear.
7 Press  or  to select the USB device if the
selection screen is displayed.
Note:
If Auto Start is set to Off, you can start the
Media Player manually.
Manual Start:
1 Insert a USB device into the USB terminal on
the left side of the TV.
2 From the FUNCTION menu, highlight Media
Player, and then press Q.
3 Press  or  to select Photo, and press Q.
The list of  les will appear.
4 Press  or  to select the USB device if the
selection window is displayed.
Viewing JPEG fi les
To view in Single View mode:
1 When the list window appears after starting
the Media Player, press  or  to select a
 le or folder.
Photo
5/8
2008/08/01 19:40
2560x1920
.JPG
//
.JPG
.JPG
.JPG
.JPG
.JPG
.JPG
.JPG
2 Press Q to begin viewing the selected  le or
to move to the next layer.
: To return to the previous layer.
3 Press  to view the next  le, or press r to
view the previous  le.
Note:
If the previous or next fi le is not compatible, it
will be skipped automatically.
To view in Slide Show mode:
1 To switch to Slide Show mode, press Q
during Single View mode.
2432PB2SeriesEn.indd182432PB2SeriesEn.indd18 2011/09/289:40:362011/09/289:40:36