Toshiba 24PB2 Series - Channel Setup and Tuning; Auto and Manual Channel Tuning

– 9 –
Location
Home
To use the TV for displaying in
a store showroom, please select [Store].
[Home] mode is recommended
for normal use.
Store mode:
AutoView menu is not available.
4 Press Q to display the AutoView menu.
Press  or  to select Yes or No.
AutoView
Yes
AutoView mode automatically
adjusts picture settings to suit
ambient light conditions. Do you
wish to enable AutoView mode?
5 Press Q to display the Auto Signal Booster
menu, and then  or  to select Yes or No.
Auto Signal Booster
Yes
Signal Booster boosts weak analogue broadcast signals.
If you select [Yes], the TV will automatically set this
feature to [On] or [Off] according to signal strength.
Do you wish to enable automatic control?
Yes mode :
This function performs automatic distinction
of On or Off.
6 Press Q to display the Auto Tuning startup
screen. Press Q to start the automatic search.
Auto Tuning
Progress
Found
1% 0
When the automatic search is completed,
the TV will automatically appear the Manual
Tuning menu.
Use the Manual Tuning operation if desired
channels cannot be preset with the Auto
Tuning or if you would like to preset channels
to speci c position numbers one by one.
1
Manual Tuning
Pos. Label
2
3
4
7 Press  or  to select the programme
position you want to arrange and press Q to
display the breakdown menu.
Press  or  to select an item, then press 
or  to select the item as shown below.
Manual Tuning
Position
0 1 B/G A0 On
ACEG
H
FDB
A. Position selection
B. System (Sound) (- page 21)
C. Colour System (- page 21)
A : Automatic (factory set), P : PAL,
S : SECAM, 4 : NTSC 4.43 (MHz),
3 : NTSC 3.58 (MHz)
If the colour of a certain channel is
abnormal, the automatic colour system
selection (A) may have malfunctioned,
or sound system selection is wrong. In
such a case, select another colour and/or
sound system (- page 21).
D. Position skip selection
Press  or  to turn the position skip
option on “8” or off “(”. The position
will then be skipped when you select
channels with PU or Pu. The “8” mark
will appear beside a position number
when you use the Number button on the
remote control.
E. Channel search operation
Press  to search up the band or  to
search down the band.
Press  or  repeatedly until your
desired channel is displayed.
When a station is found, it will be
displayed.
NEVER PRESS ANY OTHER BUTTONS
WHILE THE SET IS TUNING.
F. Manual Fine Tuning
Press  or  until better picture and
sound are obtained.
G. Signal Booster
If the receiving signal is weak/strong and
the picture is noisy, the picture may be
improved when using this function.
Press the  or  to turn the Signal
Booster On or Off.
H. Label
Station labels appear under the programme
position display each time you turn on the
TV, select a channel, or press .
To change or create station labels:
1) Press  or  repeatedly to select a
character for the  rst space, then press
 or .
*(blank space)
2432PB2SeriesEn.indd92432PB2SeriesEn.indd9 2011/09/289:40:322011/09/289:40:32