Dynamic sub bass (Z47 models only)
Volume
Press
j
— (
S
) or
j
+ (
R
) to adjust the volume.
Sound Mute
Press
k
once to turn the sound off and again to cancel.
12
General and sound controls,
stereo/bilingual transmissions
To select a programme position use the numbered
buttons on the remote control.
For programme positions below 10 use 0 and the
required number e.g. 01 for programme position 1.
Programme positions can also be selected using P
f
(
P
)
and P
e
(Q).
To revert to the previous programme position press
^^
.
To display on-screen information i.e. programme position,
input mode or stereo/mono signal, press CALL.
Press MENU and using
S
or
R
select the Sound
menu.
Press
Q
to highlight Bass, Treble or Balance
and
S
or
R
to change the setting.
Selecting programme positions
Sound controls
Bass, Treble and Balance
1
2
Select Volume correction from the Sound
menu.
Press
S
or
R
to select between AUTO
and OFF.
Volume Correction helps to reduce the difference of
volume from one programme/channel to another.
Select Dynamic sub bass from the Sound
menu.
Press
S
or
R
to select between
OFF
,
LOW
,
MID
and HIGH. HIGH is the richest sound.
This feature gives a richer sound by filtering the
sound level.
1
2
1
2
Volume 31
Sound
Bass + 8 zx
Treble 0 zx
Balance 0 zx
EXIT : To exit
Sound
Bass + 8 zx
Treble 0 zx
Balance 0 zx
Volume correction z AUTO x
Dynamic Sub Bass z HIGH x
Surround z OFF x
EXIT : To exit
Volume correction (Z47 models only)
If stereo or dual language broadcasts are transmitted the
word Stereo or Dual will appear on the screen each time
programme positions are changed, disappearing after a
few seconds. If the broadcast is not in stereo the word
Mono will appear.
Stereo… Press
OI/II to select Stereo or Mono.
Bilingual… Bilingual transmissions are rare. If they are
transmitted the word Dual will display. Choose the
required programme number and if the word Dual
appears press OI/II to select Dual 1, Dual 2 or Mono.
Stereo and Bilingual transmissions
To Next Page
Loading...
