Defining the INPUT and OUTPUT sockets so
that the television recognises connected
equipment. See page 6 for a clear view of the
back connection recommendations.
This specifies the type of signal going into SCART 2
(EXT2) on the back of the television. Please refer to the
manufacturers instructions for the connected equipment.
From the Set up menu select EXT2 input
and with
S
or
R
select either AV or
S-VIDEO as the required input.
Most VCRs and decoders send a signal through the
SCART lead to switch the television to the correct Input
socket. Alternatively press the external source selection
button
B
until the picture from connected equipment is
shown.
An S in the display e.g. EXT2S, indicates the input is set
for an S-Video signal.
Press
B
to select EXT1, EXT2 or EXT3.
To return to television mode press
B
again or
one of the numbered buttons.
Use the Input Selection if the television does not switch
over automatically.
Input selection
INPUT signal selection
1
1
2
If the colour is missing try the alternative setting.
Set up
EXIT : To exit
Language z ENGLISH x
Auto tuning x
Manual tuning x
Programme sorting x
EXT2 input z AV x
Horizontal position zx
16
Press
Q
to select Off timer. Use the number
buttons to set the required time. For example, to
switch the television off in one and a half hours
enter 01:30, or use
S
and
R
to increase/decrease
in steps of 30 minutes.
Press EXIT to finish.
To turn the television back on press
i
or one of
the number buttons.
The timer, time display,
input selection and AV connections
The time display facility allows the current time to be seen
on the television screen.
Press
8
/
9
whilst watching a normal television
broadcast to see a time display from the broadcaster. It
will remain on screen for about 5 seconds.
The television can be set to turn itself OFF after a
certain time.
The Timer
The Time Display
1
2
3
Select Timer from the top menu bar.
Timer
0 – 9 : To set
EXIT : To exit
Off timer 00:00
To Next Page
Loading...
