Toshiba 28 Series - Selecting Language and Auto Tune; Language Selection; Performing Auto Tune

Searching Ch.
25
Channel : 22
Station : BBC1
Auto tuning
  
EXIT : To exit
Set up
EXIT : To exit
Language z ENGLISH x
Auto tuning x
Manual tuning x
Programme sorting x
EXT2 input z AV x
Horizontal position zx
8
Selecting the language, Auto tune
Before running Auto tune put your decoder and video recorder (VCR) to Standby if they are connected. To set
up the television use the buttons on the remote control as detailed on page 5.
1
2
3
5
6
7
4
Press
S
or
R
to select.
Now press Q to highlight Auto tuning, then
R
to select.
Press Q to highlight Language.
To choose the required language, press MENU
and use
R
to select Set up from the top bar.
EXIT : To exit
The search will begin for all available stations.
xx xx xx
will flash and the bullet will move along
the line as the search progresses.
You must allow the television to complete
the search.
When the search is complete the television will
automatically return to programme position 1.
This may not be a clear picture or the signal may
be weak, so the station order may be changed by
using Programme sorting, on page 11.
If the television cannot be connected to a
VCR/decoder with a SCART lead use Manual
tuning to allocate a programme position,
see page 9.
Press OK to start.
Set up
EXIT : To exit
Language z ENGLISH x
Auto tuning x
Manual tuning x
Programme sorting x
EXT2 input z AV x
Horizontal position zx
Previous settings
will be lost!
EXIT for no change.
OK : START
Auto tuning