Programme: The number to be pressed on the remote control.
Search: Search up and down for a signal.
Programme skip:
*
means nothing has been stored or the facility to skip the channel is ON. See page 10.
Channel: The channel number on which a station is being broadcast.
Manual fine tuning: Only used if interference/weak signal is experienced. See page 11.
Station: Station identification. Use the
P
or Q and
S
or
R
buttons to enter up to seven characters.
Station
Programme ChannelSearch
Programme
skip
Manual fine
tuning
To allocate a programme position on the television for a decoder and VCR: turn the decoder on, insert a pre-recorded tape
in the VCR and press PLAY, then manually tune.
Each signal will show on the television, if it is not
your VCR, press
P
or Q again to restart the
search.
6
5
4
Press OK to select. If the programme is skipped,
Programme skip must be removed before
storing.
Then press
R
to select Searching.
Pressing
P
will begin the search. Searching will
flash and the television will show the channel
numbers.
9
Manual tune
The television can be tuned-in manually using Manual tuning. For example: if the television cannot be
connected to a VCR/decoder with a SCART lead.
Use
P
or Q to highlight the programme position
required e.g. we suggest Prog. 0 for a VCR.
Press MENU and using
S
or
R
select the Set up
menu, with Q highlight Manual tuning, press
R
to select.
Use
S
and
R
to move across the screen and select any of these Manual Tune options.
1
2
3
Set up
EXIT : To exit
Language z ENGLISH x
Auto tuning x
Manual tuning x
Programme sorting x
EXT2 input z AV x
Horizontal position zx
OK : To select
EXIT : To exit
Manual tuning
Prog. Channel Station
0 60 VCR
1 22 BBC1
2 28 BBC2
3 25 ITV
4 32 CH4
5 * 69
OK : To store
MENU : To return
EXIT : To exit
Manual tuning
Different
Channel
numbers
may be
displayed
Searching
0
RRR
32 0
To Next Page
Loading...
