Chapter5
SettingupyourTV
InitialSetup
When you first turn on or reset the TV, the Initial Setup window will
appear.
1 In the Menu Language field, press the ll/_(arrow) buttons to
select your preferred language.
2 Press the A/y(arrow) buttons to select Time Zone.Then set
your desired time zone, using the _I/1_(arrow) buttons and
press the ENTER button.
The Store /Home Mode settings window appears.
3 For normal home use, press the ,ll/_,(arrow) buttons to select
Home, and then press the ENTER button.
The ANT/CABLE In setup window appears.
4 Press the _ll/_,(arrow) buttons to select the input source (Cable
or Antenna), and then press the ENTER button.
5 Press the ENTER button to select Start Scan and continue with
tileAuto Tuning.
You must select a Language, either Home/Store mode, and select
ANT/CABLE before you can exit out of the Setup Menu. The
EXIT button will not function until these selections have been
made.
5O
To Next Page
Loading...
Need help?
General
