Toshiba 40L5400 Series - Page 21

21
Using the TV’s features
3 Press  or  to select Red Level, Green Level
or Blue Level, then press  or  to adjust the
setting as required.
Resetting the Colour Temperature
This function resets your colour temparature
settings to the factory settings.
1 From the Colour Temperature menu, press 
or  to select Reset, then press OK.
2 A con rmation message will appear. Press  or
 to select Ye s , and then press OK.
Activating the Noise Reduction (NR)
If the receiving signal of MPEG is a mosquito
(grained) noise depending on the compression and
conversion, the picture is weak and the picture is
blurry, the picture may be improved when using this
function.
1 From the Picture Settings menu, press  or 
to select Noise Reduction, and then press OK.
On
Auto
Auto
Noise Reduction
Auto Clean
MPEG NR
DNR
2 Select Auto Clean, and then press  or  to
select On or O .
O mode :
MPEG NR menu and DNR menu are available.
• MPEG NR mode: Low, Middle, High or O
• DNR (Digital Noise Reduction) mode: Low,
Middle, High or O
Resetting the Picture Settings
This feature resets the Picture Settings to the
factory settings.
NOTE:
If no picture settings have been changed, Reset is not
available.
1 From the Picture Settings menu, press  or 
to select Reset, and then press OK.
2 A con rmation message will appear. Press  or
 to select Ye s , and then press OK.
Setting the Contrast Booster
Contrast Booster improves the de nition of dark
areas of the picture.
1 From the Picture Settings menu, press  or 
to select Contrast Booster.
Standard
Picture Settings
Picture Mode
Backlight
Contrast
Brightness
Colour
Tint
Sharpness
Contrast Booster Middle
0
0
0
0
70
100
2 Press  or  to select Middle, High, O or
Low.
Using the Cinema Mode
A movie  lm’s picture runs at 24 frames a second,
whereas movie software such as DVD, etc., that you
enjoy watching on TV at home runs at 30 (NTSC)
or 25 (PAL) frames a second. To convert this signal
to reproduce a smooth motion and picture quality,
select the On mode.
E ective signal and setup conditions:
• When the Video input mode is selected.
• When the input signal format is 480i, 576i or 1080i
signals.
1 From the Picture Settings menu, press  or 
to select Cinema Mode.
2 Press  or  to select On or O .
NOTE:
When a DVD movie with subtitle is playing back, this
mode may not work correctly.
Adjusting the Colour Temperature
Colour Temperature increases the warmth or
coolness of the picture by setting the red, green or
blue tint.
1 From the Picture Settings menu, press  or 
to select Colour Temperature, then press OK.
2 Press  or  to select Auto, Cool, Natural, or
Warm to suit your preference.
Cool
Colour Temperature
Colour Temperature
Red Level
Green Level
Blue Level
Reset
0
0
0
32404755L5400SeriesEn.indd2132404755L5400SeriesEn.indd21 2014/07/2417:06:252014/07/2417:06:25