Toshiba 40L5400 Series - Stereo and Bilingual Transmissions

23
Using the TV’s features
Stereo and Bilingual transmissions
Setting the MTS (Multi-channel TV Sound)
Auto mode
The MTS Auto mode automatically recognize stereo/
bilingual programmes depending on the broadcast
signal.
1 Press MENU, and then press  or  to display
the SOUND menu.
SOUND
MTS
Dual
Balance
Sound Mode
Advanced Sound Settings
Auto
Auto
Dual 1
Off
On
Audio Distortion Control
Stand
TV Mounting
Dynamic Range Control
0
2 Press  or  to select MTS, and then press 
or  to select Auto or Mono.
Mono mode
If you experience noise or poor reception of any
stereo/bilingual programme, set the MTS mode to
Mono.
Noise will be reduced and reception may improve.
NOTE:
If you experience noise with a particular programme
on whose channel reception is usually good, try setting
MTS mode to Auto, then press
s
to switch to e
Mono (monaural).
Selecting the Dual 1 or Dual 2 mode
You can hear only Dual 1 or Dual 2 sound selected,
whenever bilingual programmes are received.
1 From the SOUND menu, press  or  to select
Dual.
2 Press  or  to select Dual 1 or Dual 2.
NOTE:
• When the MTS setting is in Mono mode, the Dual
menu is not selectable.
• The Dual menu setting status remains even if the TV
is turned o .
Selecting the stereo programmes
1 When a stereo programme is received,
d Stereo appears.
4 ABCD
Stereo
2 Press
s
to select the stereo/monaural mode.
d Stereo and e Mono appear cyclically on
the screen.
Selecting the bilingual programmes
1 When a bilingual programme is received,
j Dual appears.
2 Press
s
to select the sound to be heard. The
sound di ers according to the transmission
system: NICAM or German stereo/bilingual
broadcast.
Display
Sound to be heard
NICAM
German stereo/
bilingual broadcast
j Dual 1
Sub I sound Main sound
J Dual 2
Sub II sound Sub sound
e Mono
Main sound —
NOTE:
These settings are not stored in the TV memory.
Selecting the monaural programmes
If sound distortion, interruptions or silence arises in
the low sound volume level, setting the eMono 2
mode will mitigate the problem.
1 When a monaural programme is received, e
Mono appears.
2 Press
s
to select a monaural mode that is
easy to hear. e Mono 1 and e Mono 2 appear
cyclically to the screen.
NOTE:
On some cases, the reception of stereo/bilingual
broadcasts may not be possible after switching on the
e Mono 2 mode.
32404755L5400SeriesEn.indd2332404755L5400SeriesEn.indd23 2014/07/2417:06:252014/07/2417:06:25