2/2
SET UP
AV connection
OK
Picture position
OK
Quick Setup
OK
MENU
Back
EXIT
Watch TV
Input selection and
AV connections
28
Defining the INPUT and OUTPUT sockets so that the television recognises connected equipment. See page 6
for a clear view of the back connection recommendations.
Most media recorders and decoders send a signal
through the SCART lead to switch the television to the
correct Input socket.
Alternatively press the external source selection button
B
until the picture from connected equipment is shown.
This button must be used to view equipment connected
using the COMPONENT VIDEO INPUT (EXT4C).
An S in the display e.g.
B
3S (EXT 3S), indicates the
input is set for an S-Video signal.
Use the Input Selection if the television does not switch
over automatically.
Input selection
1
This specifies the type of signal going into SCART 3 (EXT3)
on the back of the television. Please refer to the
manufacturers instructions for the connected equipment.
In the SET UP menu press
Q
until
AV connection is highlighted, then press OK.
With
S
or
R
select either AV or S-VIDEO as the
required input for EXT3.
If the colour is missing try the alternative setting.
INPUT signal selection
1
2
2
Press
B
to select
B
1,
B
2,
B
3,
B
4C,
B
5,
(EXT1-5), HDMI1, HDMI2 or PC.
HDMI™ displays equipment connected to Input
HDMI on the back of the television. It is designed
for best performance with 1080i high definition
signals.
PC displays a computer connected to Input
RGB/PC on the back of the television.
To return to television mode press
B
again or
one of the numbered buttons.
AV connection
HDMI1 audio Auto.
HDMI2 audio Auto.
EXT3 input S-VIDEO
EXT3 output EXT1
Woofer External
Audio output Fixed
MENU
Back
EXIT
Watch TV
This is a digital television which is integrated to allow the
use of both digital and analogue services. However,
during the lifetime of this set it is very likely that
analogue services will be switched off to allow for more
new digital services.
This ‘switch-off’ will happen in a number of phases,
which will be advertised in your area well in advance.
It is recommended that at each phase the television is
re-tuned to ensure that existing and new digital
services can be viewed without disruption
(see Auto tuning page).
Analogue switch-off
To Next Page
Loading...
