2/2
SET UP
AV connection
OK
Picture position
OK
Quick Setup
OK
MENU
Back
EXIT
Watch TV
29
Input selection and
AV connections
continued
In the SET UP menu press
Q
until
AV connection is highlighted, then press OK.
Press
Q
to highlight EXT3 output.
1
2
HDMI, the HDMI logo, and High-Definition Multimedia
Interface are trademarks or registered trademarks of HDMI
Licensing, LLC.
HDMI audio
If the connected HDMI source does not support digital
audio, plug the audio cable into the back of the television
(as shown in the ‘Connecting a computer’ section), then
use the HDMI audio settings.
In the AV connection menu press
Q
to highlight
HDMI1 audio or HDMI2 audio. Using
S
or
R
select Auto., Digital or Analogue.
If the sound is missing select the alternative
setting.
2
Use
S
or
R
to change the EXT3 output option to:
DTV = The programme selection in digital mode.
ATV = The programme selection in analogue
mode.
EXT1 = The picture from equipment connected
to SCART 1.
EXT2 = The picture from equipment connected
to SCART 2.
EXT5 = The picture from equipment connected to
the input sockets.
Monitor = The picture on screen.
TV = The current programme selection.
This enables selection of the source to output from
SCART 3. For example, to record transmissions in stereo
from a stereo decoder – connect a stereo decoder to
SCART 1 and stereo media recorder to SCART 3, then
select EXT1 as the EXT3 output. The signal received
through SCART 1 will output directly through SCART 3.
OUTPUT signal selection for SCART 3
3
In the SET UP menu press
Q
until
AV connection is highlighted, then press OK.
1
AV connection
HDMI1 audio Auto.
HDMI2 audio Auto.
EXT3 input S-VIDEO
EXT3 output EXT1
Woofer External
Audio output Fixed
MENU
Back
EXIT
Watch TV
AV connection
HDMI1 audio Auto.
HDMI2 audio Auto.
EXT3 input S-VIDEO
EXT3 output EXT1
Woofer External
Audio output Fixed
MENU
Back
EXIT
Watch TV
To Next Page
Loading...
