Toshiba 43HX71 - Connecting an Audio System; Connecting an A;V Receiver

on page 50).
You will need:
• one pair of audio cables
Note:
Tohearsound whenusing an externalaudio amplifier,the
volume ofboth the TVand the amplifier must be set
above0 (zeroj.
Connecting an A/V receiver
This connection allows you to use an audio/video (A/V) receiver to
enhance your TV's sound.
If you have a system with Dolby Pro Logic®surround sound, you can
add to the realism of the sound by using the TV's internal speakers as
center channel speakers.
You will need:
• one pair of audio cables
• one single audio cable for the audio center channel
• one video cable
To A/V Receiver
I
I \
Video TV Center From
OUT IN OUT Antenna
TV
Note:
Refer to the instructions provided with your A/V receiver
for details about your surround sound system.
When the Audio Center Channel ON/OFF switch is in
the ON position, the TVspeakers will function only as
center channel speakers.
Adjust the volume for the center channel speakers
using the center level control on the A/V receive£
Touse the TVspeakers as normal speakers, set the
Audio Center Channel ON/OFF switch to the OFF
position.
iiiiiiiiiiiiiiiiiiiiiiiiii!
iiiiiiiiiiiiiiiiiiiiiiiiii
iiiiiiiiiiiiiiiiiiiiiiiiii!
iiiiiiiiiiiiiiiiiiiiiiiiiii
iiiiiiiiiiiiiiiiiiiiiiiiii!
iiiiiiiiiiiiiiiiiiiiiiiiii_
Caution:
Toavoid damaging thespeakers, turn the TV
off beforeconnecting or disconnectingthe
Audio Center Channelaudio cable.
Dolby Pro Logic* surround sound
system connection example
C
m ; , m
o c oo--
TV
_e,t ,oht
_peaker_ '_" _speake
Surround m Surround
speaker L _t/?L speaker R
* Dolby Pro Logic is a registered trademark
of Dolby Laboratories Licensing
Corporation.
11