Adding channels to the TV's memory
When you press Channel • or V, your TV will stop only on tile
channels stored in the TV's channel memory.
Follow the steps below and on the next page to program all active
channels into the TV's memory.
Programming channels automatically
Your TV can automatically detect all active channels in your area and
store them in its memory. After the channels are stored automatically,
you can manually add or erase individual channels (see page 25).
To program channels automatically:
1. Press MENU, and then press • or • until the SET UP menu
appears.
2. Press • or • until TV/CABLE is highlighted.
3. Press • or • to highlight either TV or CABLE, depending on
which you use. If you use an antenna, highlight TV; if you use
cable, highlight CABLE.
®®®®@@
O SET UP
LANGUAGE ENGL I SH
CLOCK SET 00:00
ADD/ERASE ADD
Note:
To tune the TV to a channel not programmed
in the channel memory, you must use the
Channel Number buttons on the remote
control
MENU
. Press • to select CH PROGRAM.
®@®®@®
SET UP
LANGUAGE ENGLISH
CLOCK SET 00:00
ANT1/2 ANT1
Channel AT
5. Press • or • to start channel programming. The TV will
automatically cycle through all the TV or Cable channels
(depending on which you selected), and store all active channels
in the channel memory.
While the TV is cycling through the channels, the message
"Programming Now--Please Wait" appears.
6. When channel programming is complete, the message
"Completed" appears.
7. Press Channel • or • to view the programmed channels.
To Next Page
Loading...
