Adjusting the color convergence
This projection TV uses three separate TV tubes: red, green, and blue.
The red, green, and blue images are projected onto the screen where
they converge to form a full-color picture. You can see a dear picture
only when the three images converge correctly. Convergence may drift
over time or if you move the TV. If you can see clear images on your
TV screen, skip this procedure.
Make this adjustment after the TV has been on for at least 30
minutes.
To use the TOUCH FOCUS (auto convergence) button:
Press TOUCH FOCUS on the TV once. The TV will enter the
auto convergence mode and correctly adjust convergence
automatically.
43HX71 TV front panel
\
MENU AY, II_ TOUCH FOCUS
53HX71
AOH
MENU EXIT TVA/IDEO TOUCHFOCUS
MENU AY,II_ TOUCH FOCUS
TOUCH FOCUS
TOUCH FOCUS FINISHED
4.............. Horizontal
B _ G
1 tl
Vertical
I
When the adjustment is complete, the normal picture will
reappear.
If the message "Touch Focus Error" appears, retry the TOUCH
FOCUS adjustment or adjust the convergence manually, as
described below.
To check and adjust the color convergence manually:
1. Press MENU, and then press • or • until the PICTURE menu
appears.
2. Press • or • to highlight CONVERGENCE.
®®0®@@
O PICTURE ANTENNA
MODE SPORTS
A
FLESH TONE ON
DNR OFF
CINEMA MODE FILM
COLOR
-- MENU
To Next Page
Loading...
