ENTER :TO SELECT COLOR
EXIT :TO SELECT POSITION
If you see separate red, blue, or green crossed lines (or red or blue
shadows next to white lines), you need to adjust the convergence.
4. Press ENTER to highlight RED or BLUE, depending on which
color needs adjusting. If both red and blue need adjusting, you
will need to perform steps 4 and 5 twice.
5. Press • (up), I' (down), • (left), or _ (right) on the remote
control to converge the red or blue line into the green line, which
will turn completely white when correctly adjusted. When color
convergence is correctly adjusted, you will see two single crossed
white lines.
6. Press EXIT to display the Circumference Convergence menu.
7. Press the corresponding Number button (1-4 and 6-9) to select
the area you want to adjust.
/ENTER
!
+
8. Press ENTER to highlight RED or BLUE, depending on which
color needs adjusting. If both red and blue need adjusting, you
will need to perform steps 8 and 9 twice for the selected area.
i+
R_m
: TO AD,JU$_
ENTER : TQ SELECT COLOR
EXIT :TO SELECTPO£{T{ON
9. Press •V• _ to converge the red or blue line into the green line,
which will turn completely white when correctly adjusted. Repea
steps 8 and 9 until you see two single crossed white lines.
10. Press EXIT once to select another area to adjust, and then repeat
steps 7-9.
11. Press EXIT twice to close the Convergence menu.
To Next Page
Loading...
