Turning off the built-in speakers
Use this feature to turn the TV speakers offwhen you connect an
audio system (see "Connecting an audio system" on page 11).
To turn off the built-in speakers:
1. Press MENU, then press • or • until AUDIO menu appears.
2. Press • or • to highlight SPEAKERS.
3. Press • or • to highlight OFE
®@®®@®
O AUDIO
_BS ON
STABLE SOUND OFF
To turn on the built-in speakers:
Highlight ON in step 3 above.
Selecting the Audio OUT sound
This feature allows you to select the sound source (MAIN or PIP) that
is output from the Audio OUT jacks.
This is useful when amplifying or recording the PiP/Double-Window
sound with external equipment while hearing the sound of the main
picture through the built-in speakers.
To select the Audio OUT sound:
1. Press MENU, and then press • or • until the AUDIO menu
appears.
2. Press • or • to highlight AUDIO OUT.
3. Press • or • to select MAIN or PIP.
®@®®@@
AUDIO
_BS ON
SBS LEVEL 100
Note:
Make sure the volume control of your audio
amplifier is set to a moderate listening level
MENU
AT<
• MAIN : Outputs the sound of the main program.
• PIP : Outputs the sound of the PiP/double-window program.
Using the StableSound TM feature
When the signal source is changed, tile stable sound feature limits the
high volume level to prevent extreme changes in volume (for example,
to prevent the sudden increase in volume that often happens when a
TV program switches to a commercial).
To turn on the StableSound feature:
1. Press MENU, and then press • or • until the AUDIO menu
appears.
2. Press • or • to highlight STABLE SOUND.
3. Press • or • to select ON.
®@®®®®
AUDIO
_BS ON
SBS LEVEL 80
SPEAKERS ON
50
To Next Page
Loading...
