Toshiba 50L9450 Series - Stereo and Bilingual Transmissions (for DTV Programmes); Stereo and Bilingual Transmissions (for ATV Programmes)

28
Using the TV’s features
Stereo and Bilingual transmissions
(for ATV programmes)
Setting the MTS (Multi-channel TV Sound)
Auto mode
The MTS Auto mode automatically recognize stereo/
bilingual programmes depending on the broadcast
signal.
1 Press MENU, and then press  or  to display
the SOUND menu.
SOUND
MTS
Dual
Balance
Sound Mode
Advanced Sound Settings
Auto
Auto
Dual 1
Off
On
Audio Distortion Control
Stand
TV Mounting
Dynamic Range Control
0
2 Press  or  to select MTS, and then press 
or  to select Auto or Mono.
Mono mode
If you experience noise or poor reception of any
stereo/bilingual programme, set the MTS mode to
Mono.
Noise will be reduced and reception may improve.
NOTE:
If you experience noise with a particular programme
on whose channel reception is usually good, try setting
MTS mode to Auto, then press
s
to switch to e
Mono (monaural).
Selecting the Dual 1 or Dual 2 mode
You can hear only Dual 1 or Dual 2 sound selected,
whenever bilingual programmes are received.
1 From the SOUND menu, press  or  to select
Dual.
2 Press  or  to select Dual 1 or Dual 2.
NOTE:
• When the MTS setting is in Mono mode, the Dual
menu is not selectable.
• The Dual menu setting status remains even if the TV
is turned o .
6 Press  or  to adjust the settings as required.
Hue Saturation Brightness
Red 0 00
NOTE:
If you select 3D Colour Management O mode, this
mode is not available.
Resetting the Base Colour Adjustment
The reset function adjusts the base colour
adjustment to the factory settings.
1 From the Base Colour Adjustment menu, press
 or  to select Reset.
2 Press OK.
3 A con rmation message will appear. Press  or
 to select Ye s , and then press OK.
Using the Picture Analyser
Displays the picture histogram.
1 From the PICTURE menu, press  or  to
select Picture Analyser.
Histogram: Shows the bright and dark areas of
the displayed picture, and the distribution of
colours in a graph.
Contrast Curve: Shows the correction curve,
which improves the expressive feel of the
displayed picture, in a graph.
To close the Picture Analyser screen, press
EXIT.
Stereo and Bilingual transmissions
(for DTV programmes)
For stereo or dual mono broadcasts, press s and
use  or  to select settings.
Mode Display
Pressing 
d Stereo Stereo S Left S Right
j Dual mono Dual 1 S Dual 2 S Dual
e Mono
–
Surround
–
For multi-audio track broadcasts, press s
repeatedly to change the audio language (- page
37).
506584L9450SeriesEn.indd28506584L9450SeriesEn.indd28 2014/08/2114:23:462014/08/2114:23:46