Toshiba 50L9450 Series - Using the Easy Remote Control to Operate the TV

46
Adjusting the Clock Phase of the picture
If the Clock Phase, which synchronize the PC signal
and LCD display, is not optimized, the picture will
blur.
This function enables you to adjust Clock Phase
and display a clear picture.
1 From the PC Settings menu, press  or  to
select Clock Phase.
2 Press  or  to obtain a clear picture.
Adjusting the Sampling Clock
If the Sampling Clock does not match with the dot
clock frequency of the PC, blurred picture detail will
occur, or screen width will change, or drift patterns
in vertical lines may be apparent.
This function enables you to adjust it and optimize
the picture.
1 From the PC Settings menu, press  or  to
select Sampling Clock.
2 Press  or  to optimize the picture.
Resetting the PC Settings
The Reset function adjusts the PC Settings to the
factory settings.
1 From the PC Settings menu, press  or  to
select Reset.
2 Press OK.
3 A con rmation message will appear. Press  or
 to select Ye s , and then press OK.
NOTE:
When a PC is connected using HDMI none of these
function will be available.
Using the Easy remote control to operate the
TV
The following TV operations can be performed
using the Easy remote control:
• When the MENU button is pressed, the menu
screen appears.
• The volume can be adjusted using the +/–
buttons.
• If you press, hold, and then tilt the pointing key
while watching the TV, the operation guide is
displayed.
Pressing, holding, and then tilting the pointing
key vertically changes the channel.
Pressing, holding, and then tilting the pointing
key horizontally changes the input.
Using the TV’s features
506584L9450SeriesEn.indd46506584L9450SeriesEn.indd46 2014/08/2114:23:502014/08/2114:23:50