Toshiba 50L9450 Series - Page 30

30
Using the TV’s features
Using the Dynamic Range Control
This feature allows control of compression for Dolby
Digital and Dolby Digital Plus.
1 From the SOUND menu, press  or  to select
the Dynamic Range Control.
2 Press  or  to select On or O .
Using the Audio Level O set
Sometimes there can be large changes in volume
when switching from a DTV 5.1ch to a DTV 2ch,
an ATV channel, or an external input. Using the
Audio Level O set feature reduces these volume
di erences.
1 Set the volume level usually used when
watching a DTV 5.1ch programme.
2 Tune to a channel which is DTV 2ch, ATV or an
external input.
3 From the SOUND menu, press  or  to select
Audio Level O set and press OK.
4 Press  or  to select an option, and then
press  or  to adjust the volume level.
Audio Level Offset
ATV
0
0
External Input
0
DTV 2ch
NOTE:
• The available item changes depending on the
current input source. For example, while watching
a DTV 2ch programme, only DTV 2ch is available
and the other two items are greyed out in the menu.
This allows you to easily adjust according to each
condition.
• When watching a DTV 5.1ch programme, this
feature is not available.
Using the Power Bass Booster
Power Bass Booster helps to create rich bass.
1 From the Advanced Sound Settings menu,
press  or  to select Power Bass Booster.
2 Press  or  to select Normal, Super or O .
NOTE:
This may not have an e ect, depending on the audio
source.
Resetting the Advanced Sound Settings
This feature resets the Advanced Sound Settings
to the factory settings.
NOTE:
If no sound settings have been changed, Reset is not
available.
1 From the Advanced Sound Settings menu,
press  or  to select Reset, and then press
OK.
2 A con rmation message will appear. Press  or
 to select Ye s , and then press OK.
Using the Audio Distortion Control
Prevents audio distortion.
1 From the SOUND menu, press  or  to select
the Audio Distortion Control.
SOUND
MTS
Dual
Balance
Sound Mode
Advanced Sound Settings
Auto
Auto
Dual 1
Off
Stand
TV Mounting
Dynamic Range Control
0
On
Audio Distortion Control
2 Press  or  to select On or O .
Selecting the TV Mounting (Wall/Stand)
TV Mounting feature can provide an appropriate
sound depending on the TV installation type, that
TV is installed on a wall or a TV stand.
1 From the SOUND menu, press  or  to select
TV Mounting.
2 Press  or  to select Wall or Stand.
506584L9450SeriesEn.indd30506584L9450SeriesEn.indd30 2014/08/2114:23:472014/08/2114:23:47