2060, 2860/70 ADJUSTMENT 1 - 2 Dec. 1996 © TOSHIBA CORP.
Group
Error code
Machine status
Service call by the paper feeding
system
Service call by the optical system
Service call by the process system
Fuser unit area
Service call by communication
Service call by ADF
Service call by sorter
Service call by the other
C11
C12
C13
C14
C15
C16
C17
C18
C21
C22
C23
C26
C33
C35
C41
C43
C44
C45
C54
C55
C56
C72
C73
C74
C81
C82
C83
C84
C85
C86
C87
C88
C93
Abnormal operation of the ADU side motor
Abnormal operation of the ADU end motor
Abnormal operation of the upper cassette tray
Abnormal operation of the lower cassette tray
Abnormal operation of the PFP upper cassette tray
Abnormal operation of the PFP middle cassette tray
Abnormal operation of the PFP lower cassette tray
Abnormal operation of the LCF tray
Carriage initialize error
Lens initialize error
Mirror initialize error
Exposure lamp burn out detected
Easy set-up is failed
Developer material exist at the transfer/separation adjustment
Abnormal thermistor or heater disconnection when power is on
Warming up mode after disconnection judgement, or abnor-
mal thermistor after ready
Warming up mode after disconnection judgement, or heater
disconnection after ready
Sub thermistor is open-circuited
Sorter — Main CPU communication error
ADF — Main CPU communication error
PFC — Main CPU communication error
Poor adjustment by the aligning sensor detected
EEROM poor initialized
Poor adjustment by the exit/reserve sensor detected
Paper transport motor abnormal
Bin shifting motor abnormal
Upper limit error
Lower limit error
Home sensor error
Staple guide bar drive motor abnormal
Staple drive motor abnormal
Copy removal sensor error
ADF original stop signal not received
Note: If there is a possibility of the heater malfunctioning as a consequence of the short-circuiting of the triac, the
microcomputer will check for abnormal temperature and send out error code “C44” and turn off the main
switch of the copier.
To Next Page
Loading...
Need help?
General