2060, 2860/70 ADJUSTMENT 1 - 4 Dec. 1996 © TOSHIBA CORP.
Quick reference chart for self-diagnostic mode
Normal
*1
“09”
“09”
* “P”: PRINT key on.
“C”: CLEAR/STOP key on.
Warming up
Standby
“06”
“C”
“01”
*2
“02”
All the displays on
the control panel lit
Aging
“07”
(With ADF)
“P” “C”
Stops momentarily
“09”
“03/04”
“05”
“08”
“05”
“09”
Setting mode
Adjustment mode
Test mode
*1 When the copier is in the adjustment mode which you entered by turning on the power switch while
pressing keys “0” and “5” simultaneously, pressing keys “0” and “9” simultaneously will make the
copier exit into the stand-by mode. In this stand-by mode only, you can access the adjustment
mode repeatedly by simply entering “0” and “5”.
*2 While all the displays on the control panel are lit (“01” mode), copying is disenabled.
When the copier enters the standby status by pressing the CLEAR/STOP key, copying is enabled.
Power ON
To Next Page
Loading...
Need help?
General