30
Before using a peel-off unit (GH30, GH40 models only)
When issuing labels in the peel-off mode, pull out the
peel-off roller before loading a label roll.
1. Open the Top cover, and push the lock lever in the
direction of the arrow.
2. This will pop-up the Peel-off Unit.
Refer to “Loading the Media” on the previous page
and set a label roll.
NOTES:
1. DO NOT PULL the center of the Peel-off roller
hard. Doing so may break the Peel-off roller.
2. Do not forcibly pull out the Peel-off roller or push it
into the printer, otherwise the Peel-off roller may
break.
How to put away the Peel-off Roller
1. Gently press the Peel-off Roller Unit down, and
push it into the printer in the direction indicated by
the arrow until it clicks.
.
Peel-off Unit
Peel-off unit
Peel-off Unit
Peel-off Unit
Lock lever
To Next Page
Loading...
Need help?
General