Toshiba Carrier RBC-AMS41UL - Page 17

Remote controller with weekly timer
Owner’s Manual
–17–
EN
 Scheduled operation setup
How to execute scheduled operations
• On the screen of the remote controller
whose power has been turned on, check
that the current day of the week and clock
time are set accurately.
Scheduled operations cannot be executed
while the days of the week display, the day
arrow and numeric display are still
blinking.
• Set at least one operation program.
Check that at least one operation
reservation display is indicated below
the days of the week on the remote
controller screen.
1 Push the button (48).
• Although first extinguished on the
timer function display, the symbol
shown on the right now starts blinking.
2 Push the button (42) within 5
seconds of completing step
1.
• The symbol on the timer function display
stops blinking and lights.
How to release a scheduled operation
1 Push the button (48).
• The symbol on the timer function display
changes from the lighted status to blinking.
2 Push the button (41) within 5
seconds of completing step
1.
• The symbol on the timer function display
stops blinking and goes off.
• Push the button (42), and enter
the program number.
• The numeric display stops blinking
and lights up.
5
• Push the TIME and buttons
(40), and set the operation time.
• If the buttons are held down for four
or more seconds, the time can be
moved forward or back in 10-minute
increments.
6
1. Selecting and setting operation/stop
Push the button (48) until
blinks on the display.
2. Selecting and setting the operation
mode
Push the button (34) until
blinks on the display.
3. Setting the temperature
Push the TEMP. and buttons
(49) until “77” blinks on the numeric
display.
4. Setting the restriction on the button
operations
Push the button (34) while
holding down the button (43) until
blinks on the display.
5. Setting the save operation
Push the button (38) until
blinks on the display.
7
• Push the button (42) to enter the
operation settings.
• With the exception of , all the
displays stop blinking and light up.
SETTING
8
• Finally, when the button (46) is
pushed, goes off, and the
original screen is restored.
9
• An underbar is displayed under the
selected day of the week.
SETTING
16-EN
+00EH99677901_01EN_OM_Remo_Weekly_UL.book Page 17 Thursday, October 8, 2009 2:03 PM