Remote controller with weekly timer
Owner’s Manual
–21–
EN
6 TIMER OPERATIONS
• Before this remote controller is shipped
from the factory, the schedule timer
operation function is set as an initial
setting (default), but the count-down timer
operation function can be selected
instead.
* Users who want the timer operation
function should refer to the “Selecting
the remote controller functions” section.
* Bear in mind that if the timer operation
function has been selected, the
scheduled operation function cannot be
used.
• The three following functions can be
selected by the timer operation function:
OFF timer:
Operation is shut down when the set time
is reached.
Repeated OFF timer:
Every time operation is started, it is shut
down after the set duration.
ON timer:
Operation is started when the set time is
reached.
* The maximum time which can be set is
168 hours (7 days).
Timer operations
How to execute timer operations
1 During operation, push the
button (48), and select the timer
operation which is to be set.
• The display and numeric display
blink, and the timer function display lights.
• Each time the button is pushed, what
appears on the timer function display
changes in the following sequence.
• Stop pushing the button when the desired
operation lights up on the display.
2 Push the TIME and buttons
(40), and select the set time.
• Each time the button (40) is pushed,
the set time is moved forward in half-hour
(30-minute) increments. If the set time is
more than one day (24 hours) ahead, it is
moved forward in 1-hour increments. The
upper limit is 7 days (168 hours) ahead.
The numbers representing any set time
from 0.5 hour to 23.5 hours appear on the
numeric display.
For a set time more than 24 hours ahead,
the number of days and time are indicated.
• Each time the button (40) is pushed,
the set time is moved back in half-hour (30-
minute) increments (from 0.5 hour to 23.5
hours) or in 1-hour increments (from 24
hours to 168 hours).
Example of remote controller display
• When the set time is 23.5 hours ahead
• When the set time is 34 hours ahead
3 Push the button (42).
• The numeric display stops blinking and
lights up, and the timer function display
changes to blinking from its lighted status.
• The display goes off.
* When the ON timer function is set, the
operation of the air conditioner is shut
down. This means that apart from the
lighted numeric display and blinking
timer function display, all other displays
go off.
How to cancel a timer operation
1 Push the button (41) during the
timer operation.
• The timer function display and numeric
display go off.
* A timer operation can be canceled while
the timer operation is being set or
executed.
SETTING
No timer
(No display)
OFF timer Repeated
OFF timer
ON timer
“1d” = 1 day = 24 hours
“10H” = 10 hours
Total = 34 hours
SETTING
20-EN
+00EH99677901_01EN_OM_Remo_Weekly_UL.book Page 21 Thursday, October 8, 2009 2:03 PM
To Next Page
Loading...
