Toshiba Carrier RBC-AMS41UL - Page 19

Remote controller with weekly timer
Owner’s Manual
–19–
EN
6 Again push the button (45).
• Repeatedly push the button until the day
arrow moves to the copy destination day
of the week.
• The day arrow blinks while the copy
destination is being selected.
7 Push the button (42).
• The settings of the copy source day of the
week are copied into the copy destination
day of the week.
• The blinking of the day arrow displayed
for the copy destination day of the week
changes to the lighted operation
reservation display.
* Copying involves overwriting any
existing settings.
Bear in mind that the original setting of
the copy destination will be deleted
when the button (42) is pushed.
8 To continue copying, repeat steps 4
to
7.
9 Finally, push the button (46) to
return to the original screen.
 Editing the operation programs
(instructions for clearing)
• Operation programs which have been set
can be cleared (deleted) in two ways.
1. All the programs for a specific day of the week
can be cleared.
2. A specific program on a specific day of the
week can be cleared.
* The program settings can be cleared whether
the air conditioner is running or shut down.
How to clear the program settings
How to clear the programs for a specific
day of the week
1 Push the button (46).
• The display transfers to the program input
screen.
• The entire LCD screen blinks.
2 Push the button (45).
• Repeatedly push the button until the day
arrow moves to the day of the week
whose programs are to be cleared.
3 Push the button (42).
• Enter the day of the week whose programs
are to be cleared.
• The days of the week display and day
arrow stop blinking and light up.
4 Push the button (37).
• Repeatedly push this button
until “PG-CL” (shown right)
appears on the numeric display.
* PG-CL ...... P
ROGRAM-CLEAR
5 Push the button (42).
• The settings of all the programs which
have been set and displayed for the day of
the week are cleared (deleted), and the no
program set status blinks on the screen.
* Bear in mind that cleared settings
cannot be restored.
6 To continue clearing, repeat steps 2
to
5.
7 Finally, push the button (46) to
return to the original screen.
How to clear individual programs on the
same day of the week
1 Push the button (46).
• The display transfers to the program input
screen.
• The entire LCD screen blinks.
2 Push the button (45).
• Repeatedly push the button until the day
arrow moves to the day of the week for
which a program to be cleared has been
set.
3 Push the button (42).
• Enter the day of the week for which the
program to be cleared has been set.
• The days of the week display and day
arrow stop blinking and light up.
4 Push the button (37).
• Repeatedly push this button until the
number of the program to be cleared
appears on the numeric display.
• The program number displayed blinks.
18-EN
+00EH99677901_01EN_OM_Remo_Weekly_UL.book Page 19 Thursday, October 8, 2009 2:03 PM