Toshiba CIX - Step 2 G: Create Dial 0 Destination; Step 2 H: Direct CO Lines to Ring CIX Attendant Console

Installation
Step 2: Program CIX for the Console
6 Strata CIX IP Attendant Console Installation 01/09
Step 2G: Create Dial 0 Destination
 Enter Program 102, then enter data for the FB listed below:
p FB00 – In CIX eManager, click the Create button to assign Attendant Console Group DN.
In the pop-up window, enter an Index value of 0 (zero), click OK. Most sites will use 0;
however; any non-conflicting DN can be used.
...or for telephone programming, at the “Digit=” prompt, enter 0 (or any DN that does not
conflict with a station DN). At the “FB0=” prompt, enter 750.
Note The number entered here (usually 0), is the number users dial to reach an Attendant.
Important! Do not assign a PDKU or BDKU port as DN = 0.
Step 2H: Direct CO Lines to Ring CIX Attendant Console
Refer to the Strata CIX Programming Manual Volume One for details.
The Attendant dialing digit is “0.”