Toshiba e-studio 151D - Page 53

e-STUDIO162/162D/151/151D DISASSEMBLY AND ASSEMBLY 8 - 10
5) Disconnect the connector from the MCU PWB.
6) Disengage the pawls (2 positions), and remove the sensor PWB.
7) Remove the screw, and open the upper paper guide.
8) Remove the roller, and remove the belt.
9) Disengage the pawl, and remove the roller knob.
10) Disengage the pawl, and shift the pulley and the bearing.
11) Remove the paper exit roller, and remove the belt, the pulley, and
the bearing.
12) Remove the connector and the screw, and remove the speaker
unit. (When the GD-1190 is installed)
Caution: Be careful not to touch the sharp edge on the circumference
of the metal frame for the speaker.
1)
2)
3)
1)
1)
2)
1)
2)
1)
2)
3)
4)
1)
2)
2)
1)
3)
08_DISSASEMBLY.fm 10 ページ ２００４年１２月２３日 木曜日 午後１時４４分