Toshiba e-studio 151D - Page 54

e-STUDIO162/162D/151/151D DISASSEMBLY AND ASSEMBLY 8 - 11
13) Remove the flat cable and the grounding wire.
14) Remove the four screws, and remove the FAX PWB unit. (When
the GD-1190 is installed)
Caution: Be careful not to touch the sharp edge on the circumference
of the metal frame the interface.
15) Disconnect the connectors.
16) Remove the three screws, and remove the MCU PWB.
17) Remove two screws and remove the toner motor.
18) Remove the three screws, and remove the DUP motor unit and the
belt.
19) Remove the harness guide.
20) Remove the five screws and the grounding wire, and remove the
main drive unit.
2)
1)
3)
3)
4)
3)
3)
1)
1)
1)
2)
2)
2)
3)
Caution:
Be careful not to touch the sharp
edge on the inner side of the
interface metal frame .
1)
2)
1)
1)
2)
3)
1)
2)
1)
1)
1)
CAUTION:Attach the gears securely
08_DISSASEMBLY.fm 11 ページ ２００４年１２月２３日 木曜日 午後１時８分