1 TROUBLESHOOTING FOR THE HARDWARE
28 Clearing a Paper Misfeed
Paper misfeed in the Job Separator and the Offset Tray (both optional)
The procedure below is for e-STUDIO207L/257/307 with the Job Separator or the Offset Tray installed.
However, it does not apply to e-STUDIO357/457/507 with the Job Separator installed.
Be careful not to let your fingers be caught between the equipment and the duplexing unit or
automatic duplexing unit.
This could injure you.
Do not touch the fuser unit or the metal portion around it.
Since they are very hot, you could be burned or the shock could cause you to get your hand injured in the
machine.
4
Close the cover inside of the equipment.
5
Close the automatic duplexing unit.
1
Open the automatic duplexing unit on the right.
2
Open the cover inside of the equipment.
3
Remove the misfed paper.
To Next Page
Loading...
