2.PRINTING FROM WINDOWS
Before Using the Printer Driver 11
2 PRINTING FROM WINDOWS
2
Select the printer driver of this equipment, and select as follows: [File] menu -> [Run as
administrator] -> [Properties] Enter the administrator password if required.
y If the [File] menu is not displayed, press [Alt].
y The User Account Control dialog box appears.
y The Printer Driver Properties dialog box appears if the User Account Control setting is disabled. Go to step 4.
3
Click [Continue] in the User account control dialog box.
y The printer driver properties dialog box appears.
4
Display the [Configuration] tab, and set the following options.
Model Selection — This sets the model type of the equipment.
Drawers — This sets whether the drawers or LCF (optional) are installed.
Finisher — This sets whether or not the optional finisher is installed.
Hole Punch Unit — This sets whether or not the optional hole punch unit is installed.
LCF is not available for some countries or regions.
For more information about each item, see the descriptions about the Configuration Tab.
P.56 “Configuration Tab”
5
Click [Drawer Settings].
y The Drawer Settings dialog box appears.
To Next Page
Loading...
Need help?
General
