e-STUDIO2330C/2820C/2830C/3520C/3530C/4520C © 2008 TOSHIBA TEC CORPORATION All rights reserved
2-4
* The subcode varies according to the area where the density is adjusted. Refer to the table below and set
the subcode for the area to be adjusted. The density of light text or a graphic image will vary, if the
medium- or high-density area is mainly adjusted. Setting "0" for the subcode allows you to adjust the low-
density area. But it will not affect the light text or graphic images. Therefore, never change the value for
the low-density area.
Subcode Area where the density is adjusted
1 Medium-density area
2 High-density area
Precautions after the completion of the adjustment
The adjustment may possibly cause an increase in the amount of toner used, moiré, blurred text (small, dark text
blurred), diminished photo images or gradational images (less accurate reproducibility of halftones). Therefore,
carefully perform the adjustment, while checking the copy image.
Remarks
Enter a value within the recommended value range mentioned in the procedures. Otherwise, it may cause a loss in
MFP performance, including degradation in the image quality and a reduction in the life of the consumables.
2. Copier-specific Adjustments
To Next Page
Loading...
