e-STUDIO2330C/2820C/2830C/3520C/3530C/4520C © 2008 TOSHIBA TEC CORPORATION All rights reserved
ii
2.16.1 To Adjust the Tint of Colors other than Black ...........................................2-65
2.16.2 To Adjust the Reproducibility of Black in the Red and Black Mode ..........2-66
2.16.3 To Adjust the Boundary between Black and Colors other than Black.......2-67
2.17 To Adjust the Image Quality Scanned from the RADF................................2-68
2.18 To Program Frequently Used Copy Settings (To Use Custom Mode) .............2-71
2.18.1 To Adjust Custom Mode Settings in Black Mode......................................2-71
2.18.2 To Adjust Custom Mode Settings in Color Mode......................................2-76
2.19 To Copy While Erasing Shadow Outside of Image .....................................2-80
2.20 To Avoid Copying Blank Page of Original Scanned with RADF..................2-81
2.21 To Obtain Image in Even Density Level......................................................2-83
3. Printer-specific Adjustments
3.1 To Maintain a Steady Color Balance.............................................................3-1
3.2 To Maintain a Steady Color Balance on Thick Paper or Special Paper ..............3-3
3.3 To Obtain the Desired Color Balance ...........................................................3-5
3.4 To Closely Match the Color Balance on the Monitor...................................3-13
3.5 To Maintain a Uniform Gray Hue (To maintain Consistency in Gray among Text,
Photos and Graphics
) ...................................................3-16
3.6 To Use Only the Black Toner to Reproduce Gray Areas (
To use only the black toner
to reproduce black-and-white photos or gradational images
) .....3-19
3.7 To Easily Adjust the Overall Brightness ......................................................3-23
3.8 To Adjust the Overall Saturation .................................................................3-26
3.9 To Easily Adjust the Overall Contrast .........................................................3-30
3.10 To Obtain a Sharper Print Image ................................................................3-33
3.11 To Obtain a Softer Image............................................................................3-36
3.12 To Make Low-resolution Data Look Finer
(
To soften an image
)
..........................3-39
3.13 To Eliminate Smudges from Highly Colored Text and Lines (
To prevent toner
scattering around text and lines where a large amount of toner is used
) .....3-42
3.14 To Clearly Print Light-Colored Thin Lines or Text .......................................3-46
3.14.1 To Adjust the Print Image Quality in the Color Mode................................3-47
3.14.2 To Adjust the Print Image Quality in the Black and White Mode ..............3-55
3.15 To Make the Light-Colored Area Darker on the Printout .............................3-59
3.16 To Clearly Print Thin Lines/Double Lines....................................................3-65
3.17 To Decrease the Image Density and Save Toner
(To Print in the Toner Save Mode)...................................3-68
3.18 To Adjust the Image Density in the Toner Save Mode................................3-71
3.19 To Print Illegible Gray or Colored Text in Black ..........................................3-74
3.20 To Ignore Blank Pages for Printing .............................................................3-76
3.21 To Sharply Print Black Text ........................................................................3-79
3.22 To Prevent Dark Toner from Coming Off ....................................................3-89
Table of Contents
To Next Page
Loading...
