7 CHECKING THE EQUIPMENT STATUS WITH TopAccess
130 Error Codes
2D68
File Sharing service is not available Ask your administrator whether the SMB
protocol is enabled.
2D69
NetWare service is not available Ask your administrator whether the NetWare
protocol is enabled.
2DA6
Failure to delete file Delete the files in the shared folder with
Explorer, turn the power OFF and then back
ON, and reattempt the problem job. If the
error still persists, contact your service
representative.
2DA7
Failure to acquire resource Turn the power OFF and then back ON. Try
the problem job again. If the error still
persists, contact your service representative.
2DC0 Job canceled The job was canceled.
2DC1
Power failure occurred Make sure that the power cable is
connected properly and is inserted securely.
Resend the job.
Store to USB
2E10, 2E12,
2E13
Wrong Job status Turn the power OFF and then back ON. Try
the problem job again. If the error still
persists, contact your service representative.
2E11
Not enough memory Wait for a while and try again. If the error still
persists, turn the power OFF and then back
ON, and make another effort.
2E14
Invalid parameter specified If you are using a template, create it again. If
the error still persists, turn the power OFF
and then back ON, and then try again.
2E15
Exceeding maximum file capacity Divide the file into several files, or reattempt
in a single-page format.
2E30
Failure to create directory Make sure that the access privilege to the
storage directory is writable and also that the
disk in the directory has enough space, and
then try again. If more than one job is
performed simultaneously, the error may
occur because the disk temporarily runs out
of space. In this case, wait for a while and try
again. If the error still persists, turn the
power OFF and then back ON, and make
another effort.
2E31, 2E33
Failure to create file Make sure that the access privilege to the
storage directory is writable and also that the
disk in the directory has enough space, and
then try again. If more than one job is
performed simultaneously, the error may
occur because the disk temporarily runs out
of space. In this case, wait for a while and try
again. If the error still persists, turn the
power OFF and then back ON, and make
another effort.
2E32
Failure to delete file Turn the power OFF and then back ON. Try
the problem job again. If the error still
persists, contact your service representative.
Error Code Problem Description Corrective Action
To Next Page
Loading...
