5. Using Template
Scanning Guide — Scanning Using Template 63
8. If the “To continue, place document on glass. And press
Scan!” message is displayed, place another original on glass
and press [SCAN!] to scan another original, or press the
[JOB FINISH] button to finish scanning.
• When the original is set on the reversing automatic document feeder, this
screen is not displayed. However, this screen is displayed when you press
the [CONTINUE] button during scanning the originals.
• If you want to cancel the storage of the scanned data, press the [JOB CAN-
CEL] button.
• You can change the setting of the original type and scanning conditions,
using the [EDIT] button before pressing the [SCAN!] button.
Using Scan to E-mail template when SMTP Authentication is enabled
When the SMTP Authentication is enabled, operate the following procedure to use the
template that is registered the Scan to E-mail agent.
1. Place the original(s).
• For instruction about placing the originals, see Operator’s Manual for
Basic Function.
2. Press the [SCAN] button on the control panel to enter the
scan menu.
• The basic scan menu is displayed.
To Next Page
Loading...
