Toshiba e-STUDIO 352 - Page 183

Setting Up the UNIX Filters 183
5
Create the following file.
/etc/lp/interfaces/<queue name>.conf
6
Add a line as below in the <queue name>.conf.
dest=<IP address>
7
Save the file.
8
Enter the following command:
mkque -q <queue name> \
-a s_statfilter = /usr/lib/lpd/bsdshort \
-a up = TRUE -a host = <IP address> -a rq = dssc
9
Enter the following command:
mkquedev -q <queue name> -d dev_<queue name> \
-a backend = /opt/toshiba/tap/bin/estbwBackend
10
Enter the following command:
cp /usr/lib/lpd/pio/predef/net_estbw \
/opt/toshiba/tap/filter/<queue name>
Creating a print queue manually on Linux
1
Enter the following command:
ls /opt/toshiba/tap/interface
2
If the above directory does not exist, enter the following command:
mkdir /opt/toshiba/tap/interface
3
As root open your Linux/UNIX editor.
4
Open your Linux/UNIX editor.
5
Create the following file.
/opt/toshiba/tap/interface/<queue name>.conf
6
Add a line as below in the <queue name>.conf.
dest=<IP address>
7
Save the file.
8
Enter the following command:
cp /opt/toshiba/tap/model/net_estbw \
/opt/toshiba/tap/interface/<queue name>
9
Enter the following command:
/opt/toshiba/tap/bin/modPrintcap \
-a <queue name> <IP address>
10
Enter the following command:
ls /opt/toshiba/tap/bin/flag_<queue name>
11
If the above file exists, enter the following command.
/opt/toshiba/tap/bin/printconf_import \
-a <queue name> IP_ADDRESS \
rm /opt/toshiba/tap/bin/flag_<queue name>
12
Restart your lpd.