Monitoring Print Jobs with TopAccessDocMon 351
2
Click [Start Discovery] to begin the process.
y TopAccessDocMon locates the compatible printers in your network.
y You can quit the process by clicking [Stop Discovery].
y It may not find the device that is located in the different segment. If a device cannot
be found, find a device manually from the [Manual Selection] button.
P.352 “Finding a printer by entering printer address manually”
y If the process continues for a long time, it is because too many network clients are in
the network. Also, you must change the discover settings if you want to search for a
printer in the IPX/SPX network. In these cases, please configure the discovery set-
tings using the [Advanced] button.
P.354 “Configuring Discovery Settings”
When the equipment is connected to the IPX/SPX network of the NDS or NDPS environ-
ment, the equipment cannot be discovered on Windows 98/Me. In this case, please con-
figure the connection manually.
P.352 “Finding a printer by entering printer address manually”
3
When the process is complete, the printers that have been found
are listed in the list.
To Next Page
Loading...
